LG LDE3015SW Installation Instructions Manual
Electric double oven range
Hide thumbs
Also See for LDE3015SW:
- Owner's manual (49 pages) ,
- Manual de propietario (48 pages) ,
- Installation manual (24 pages)
Related Manuals for LG LDE3015SW
Summary of Contents for LG LDE3015SW
- Page 1 Life's Good \,J F% U ELECTICDOU LE Please read these instructions thoroughly before installing and operating the range. P/No.: MFL63290401...
-
Page 2: Before You Begin
BEFORE YOU BEGIN Remove all tape and packing materials before using the range. Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials. iMPORTANT SAFETY iNSTRUCTiONS Read and follow all instructions before using your oven to prevent the risk of fire, electric shock, personal injury, or damage when using the range. - Page 3 • The middle (neutral or ground) wire of a 3 wire power cord or a 3 wire conduit has to be connected to the middle post of the main terminal block. The remaining two wires of the power cord or conduit have to be connected to the outside posts of the main terminal connection block.
-
Page 4: Prepare To Install The Range
PREPARE TO iNSTALL THE RANGE TOOLS NEEDED • The information this manual should be followed exactly. Phillips Screwdriver Level - A fire or electrical shock may result causing property damage, personal injury or death. Flat-blade Adjustable Wrench Screwdriver • Any person should not Nut Driver 1/4"... -
Page 5: Clearances And Dimensions
iNSTALLATiON DRAWINGS (LDE Series only) NOTE • You should use two or more people to move SAVE FOR THE USE OF THE LOCAL and install range. (Excessive Weight Hazard) ELECTRICAL INSPECTOR. - Failure to do so can result in back or other injury. CLEARANCES AND DIMENSIONS (Figure 1) •... -
Page 6: Range Cord
[-_ ELECTRICAL CONNECTION [=4-7CONNECT RANGE CORD REQUIREMENTS This appliance must be installed and grounded on a branch circuit by a qualified technician in accordance with the • You never remove the protection cover National Electrical code ANSl/NFPA NO. 70 - latest edition. covering the rear of lower oven. - Page 7 • The middle (neutral or ground) wire of a 3 Cord Strain relief wire power cord or a 3 wire conduit has to be connected to the middle post of the main terminal block. The remaining two wires of the power cord or conduit have to be connected to the outside posts of the main terminal connection block.
- Page 8 Install the conduit as follows: Remove the Conduit connection plate from the rear of lower oven and rotate it as shown in Figure 5. The • Only a 4=conductor power-supply cord kit conduit hole (11/8 ") must be used. rated 120/240 volts, 50 amperes and marked for use with ranges with closed= First, prepare the conduit wires as shown in Figure 10.
- Page 9 1.Followthe instructionsunder"Installthe conduitas 4-wire connection follows" on page7 to correctlyinstallthe strain relief. BJack White DO NOT install the conduit without a strain relief. TerminaJ 2. Loosen the 2 lower left and right screws from the terminal block. (Refer to Figure 12.) Remove the lower 2 center screws.
-
Page 10: Anti-Tip Device Installation
Replace the access cover on the back of the range. To replace the wire cover, insert the two tabs into the openings located below the opening and tighten the three screws. leveler Raise _ range Use a level to check your adjustments. Place the level diagonally on the oven rack, and check each direction... - Page 11 Life's Good 1-800-243-0000 USA, Consu _r_er User 1-888-865-3026 USA, Cornmercal User 1-888-542-2623 CANADA www.lgocom Printed in Mexico...