Troubleshooting; If You Have Any Of These Problems - Panasonic DX-1100 Manual

Panafax df-1100 facsimile machine

Table of Contents

08001000001

If You Have Any of These Problems

Mode

08001020001

During Installation

08001080001

#@multitude

08001080002

During Transmission

08001080105

#@multitude

Transmission Copy

Quality

08001080004

During Reception

08001080091

Symptom

Battery discharged completely.

The display is blinking

installation. After setting the clock, the blinking will stop.

1. Check that your document is free of staples and paper

Document does not

clips, and that it is not greasy or torn.

feed/multiple feed

2. Check that your document is the right type to send through

a fax machine by consulting the list on "Documents You

Cannot Send". If your document has the characteristics

listed, send the documents using the Flatbed.

3. Check that the document is loaded properly.

4. Adjust the ADF Pressure.

The information code 031 will appear on the display if the

Document jam

document becomes jammed.

1. Check if Stamp LED is lit.

Does not stamp

2. Check Fax parameter No. 04 and No. 28 settings.

Replace stamp or refill ink.

Stamp too light

Check own copy quality. If copy is OK, your machine has no

Vertical lines on the

problem, report to receiving party that they have a problem. If

transmitted document

copy is NG, clean the Document Scanning Area.

1. Make sure the document is set face down.

Transmitted document

is blank

2. Check own copy quality. If copy is OK, your machine has no

problem, report to receiving party that they have a problem.

If copy is NG, clean the Document Scanning Area.

The information code 010 will appear on the display if the paper

No recording paper

runs out.

The information code 001, 002 or 003 will appear on the display

Recording paper jam

if the paper gets jammed.

Make sure that there is paper in the Paper Cassette. Follow

Recording paper does

the instructions for loading paper.

not advance into

machine

Check to see if the recording paper is jammed inside of the

Recording paper does

machine.

not eject after printing

1. Check if Fax Parameter No. 65 is set to valid.

Recording papers are

not stacked in

2. If memory becomes full during reception, the machine will

sequence. Machine

start to print from the 1st page received. We recommend that

optional memory is installed if this symptom is encountered

does not print from the

frequently.

last page received.

Check Print Reduction settings.

Document auto

reduction does not

work

The information code 041 will appear on the display if the Toner

Out of toner

Cartridge runs out of toner.