Table of Contents
Advertisement
Option Settings
Setting 10-2: PBX SELECT
This sets the mode used for connecting calls from a PBX to an outside line.
Refer to your PBX manual or consult your supplier for the correct setting.
Make the selection by entering a number from 1 to 3 as follows:
1:
Earth
Flash
2:
3:
ID
Initial setting: 3
(If you select 3, Setting 10-3 will subsequently appear in the display. If you
select 1 or 2, Setting 10-4 will appear.)
Setting 10-3: PBX ID NO.
If you set Option Setting 10-2 to 3 (PBX ID digit mode), use this setting to
enter your PBX ID number (maximum of 3 digits). Press the
START/MEMORY key when finished.
Initial Setting: 0
(Note: The ID number is automatically dialled for access to the public line when
Rapid Key or Speed Dialling is used. Do not store it as part of the number when
storing a Rapid Key or Speed Dialling number.)
Setting 10-4: REGISTER RECALL
This sets the recall mode used for special functions of some PTT's (e.g.
Germany, Sweden), as well as transferring calls on a PBX. Refer to your PBX
manual or consult your supplier for the correct setting. Make the selection by
entering a number from 1 to 3 as follows:
Earth
1:
2:
Flash
3:
No operation
Initial setting: 2
108
Advertisement
Table of Contents
