Table of Contents
Advertisement
Tape Remaining
When you load a video cassette into the Unit, the Unit can calculate
approximately the amount of video tape remaining in hours and
minutes. This is useful in determining whether or not there is suffi-
cient tape left to make a recording.
When a video tape is playing, the amount of tape remaining is
calculated automatically. To display the amount of video tape
remaining:
1
Load the video cassette into the Unit.
2
Press DISPLAY as many times as necessary until "R" appears
on the VCR Front Panel display. The tape will wind forward for a
few seconds and then return to its original position. The tape
remaining will be shown on the VCR Front Panel display in hours
and minutes. By pressing TAPE SPEED on the Remote the
remaining time will change between standard play, long play and
extended play.
• If the TAPE REMAINING function is interrupted, the remaining time will
not be displayed.
• If less than 5 minutes of tape remains the display will flash.
• When you start recording or playback, the VCR will begin the
computation. However, this may take some time. When the
computation is completed, the tape remaining will be shown on the
OSD and VCR display for 5 seconds.
• If the "REM" mode is selected with MODE OSD or DISPLAY and the
VCR is in Stop mode, the tape will automatically fast forward or rewind
for a few seconds and then the VCR will begin computing the amount
of tape remaining.
• During computation, REC will not function and pressing STOP,
PLAY/X2 or other buttons will interrupt the computation.
• Setting the DPSS or ZERO BACK function during computation may
cancel it.
• The indicated length of tape remaining is only an approximate guide.
• This function may not work properly for video tapes other than E-60,
E-90, E-180 and E-240.
• The length of tape remaining during fast forward or rewind may be
indicated as greater than it actually is.
C
S
• When
and
indication may not be correct.
DVNC70H071_072.pm6
C
tapes are used with a cassette adapter, the
www.sharp.co.uk/support
71
TIMER
OPERATE
VIDEO Plus+
EJECT
ON/OFF
ON
VCR/DVD
VCR MENU
DISPLAY
SCREEN
SELECTOR
DVD SETUP
FUNCTION
PROG/
OPEN/
ANGLE
CONTROL
REPEAT
CLOSE
TITLE
DVD MENU
CLEAR
SET
RETURN
ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
AM/PM
INPUT SELECT
VCR DVD
/
REV
FWD
PLAY
REC
PAUSE/STILL
STOP
TAPE
DPSS
SKIP
SLOW
SPEED
AUDIO
CH
OUTPUT
VCR
DVD
VCR/DVD COMBINATION
RRMCGA054WJSA
20/8/02, 12:38 pm
71
Advertisement
Table of Contents
