Tone/Voice First Signaling - Toshiba Strata DK8 User Manual

STRATA DK DIGITAL TELEPHONE
To Receive an Intercom Call
(Voice First Signaling):
1. You will hear a single long
tone, followed by the caller's
voice.
2. Lift the handset.
To Change the Signaling
Method:
1. Call another station via
intercom.
2. Dial 1.
3. Speak to the party when the
call is answered.
2-16
If you receive busy tone:
To set Automatic Call Back (ACB), dial 4 .
To activate Busy Override if the called station is not equipped for Off-
hook Call Announce (OCA), dial 2.
To activate OCA: With Voice First Signaling and the called station is
equipped for OCA, dial 2. With Tone Signaling and the called station
is equipped for OCA, dial 21.
Dial 3 to enter the station's conversation (Executive Override, system
programmable option).
To leave a Message Waiting Indication at the called station, dial 7.
The Intercom LED will flash green at the incoming call rate.
If the call was made with Tone signaling instead of Voice First Signaling,
your phone would ring.
The Intercom LED will flash green at the in-use rate after you lift the
handset.

TONE/VOICE FIRST SIGNALING

Your STRATA DK system may be set for Tone Signaling or Voice First
Signaling as the standard intercom call signaling method. The Tone
Signal consists of successive ring tones, while the Voice First Signal
consists of a tone burst followed by the caller's voice. You can change to
the alternate signaling method on a call-by-call basis.
Depending on the system signaling method, the following will happen:
If Tone Signaling, you will hear a ring tone (one second) every four
seconds.
If set for Voice First Signaling, you will hear a tone burst and then
you will be able to converse.
After you dial 1, the other method will be activated.
FEATURE OPERATION