Accessories; Installation - GE MDS 4710A Technical Manual

MDS 05-3305A01, Rev. E

1.5 Accessories

The transceiver can be used with one or more of the accessories listed in
Table 3. Contact GE MDS for ordering information.
Table 3. Optional Accessories for MDS 4710/9710 Transceivers
Accessory
Power Supply Kit
Hand-Held Terminal
Kit (HHT)
RTU Simulator
Orderwire Module
Orderwire Handset
RJ-11 to DB-9 adapter
EIA-232 to EIA-422
Converter Assembly
Radio Configuration
Software

2.0 INSTALLATION

There are three main requirements for installing the transceiver:
• Adequate and stable primary power
• A good antenna system, and the correct data connections between
the transceiver, and
• The data device.
Figure 4 shows a typical remote station arrangement.
MDS 4710/9710 Technical Manual
Description
Provides nominal 13.8 Vdc from a
120 Vac power source. Includes DC
cable for transceiver.
Terminal that plugs into the radio for
programming, diagnostics and control.
Includes carrying case and cable set.
Test unit that simulates data from a
remote terminal unit. Comes with
polling software that runs on a PC.
Useful for testing radio operation.
External device that allows temporary
voice communication. Useful during
setup and testing of the radio system.
Used with Orderwire Module (above)
Standard Handset
Handset with PTT
Used to connect a PC to the radio's
DIAG (Diagnostics) port
External adapter plug that converts the
radio's DATA INTERFACE connector
to EIA-422 compatible signaling.
Provides diagnostics of the transceiver
(Windows-based PC required).
GE MDS
P/N
01-3682A01
02-1501A01
03-2512A01
02-1297A01
12-1307A01
12-1307A02
03-3246A01
03-2358A01
03-3156A01
5