Using Nokia Network Voyager To Manage Your Appliance - Nokia IP200 Series Installation Manual

3
Performing the Initial Configuration
how to use Network Voyager, the CLI, and Nokia Horizon Manager are
provided in the following sections.
Using Nokia Network Voyager to Manage Your
Appliance
You can use Nokia Network Voyager, an SSL-secured, Web-based element
management interface to Nokia IP security platforms, to configure and
monitor your appliance. Network Voyager is preinstalled on the IP200
appliance and enabled through the IPSO operating system. With Network
Voyager, you can manage, monitor, and configure the IP200 appliance from
any authorized location within the network by using a standard Web browser.
To open Nokia Network Voyager
1. Start a Web browser on the host you plan to use to configure or monitor
your appliance.
2. In the Location or Address field, enter the IP address of the initial
interface you configured for the appliance.
You are prompted to enter the admin username and the password you
entered when you performed the initial configuration.
Note
If the username login screen does not appear, you might not have a
physical network connection between the host and your appliance, or you
might have a network routing problem. Confirm the information you
entered during the initial configuration and check that all cables are firmly
connected. For more information, see
46
Chapter 8, "Troubleshooting."
Nokia IP200 Series Security Platform Installation Guide