Figure 8 Power Switch Location - Nokia IP200 Series Installation Manual

3
Performing the Initial Configuration

Figure 8 Power Switch Location

To connect the power supply
1. Connect the power cord securely into the power cord receptacle on the
power supply.
2. Plug the other end of the power cord into a grounded power strip or wall
outlet.
3. Toggle the power switch to the on position to provide power to the IP200
appliance.
Caution
To reduce stress on the power supply, when you turn the appliance
on, wait at least ten seconds before you turn it off. Likewise, when
you turn the power supply off, wait at least ten seconds before you
turn it back on.
Note
Because the flash-memory PC card is hot replaceable for the IP200,
you do not need to install a flash-memory PC card to boot from before
you turn on the appliance.
42
Power cord receptacle
Nokia IP200 Series Security Platform Installation Guide
Power switch 00321