Table of Contents
Advertisement
2
Performing the Initial Configuration
Connecting Power and Turning the Power On
A power switch and a receptacle for the power cord are located on each power
supply on the back of the appliance as shown in
Figure 9 Power Switch Location
Power cord receptacle
Caution
To avoid potential service interruptions from momentary facility
power interruptions and potential power spikes that might damage
your equipment, Nokia strongly recommends that you use an
uninterruptible power supply (UPS) with surge protection with your
IP1200 Series.
To connect the power supply
1. Connect the power cord securely into the power cord receptacle on the
2. Plug the other end of the power cord into a three wire grounded power
3. Toggle the 1/O power switch to the 1 position to provide power to the
42
Power supplies
power supply.
strip or wall outlet.
IP1200 Series.
Power switch
Nokia IP1200 Series Security Platform Installation Guide
Figure
9.
00308a
Advertisement
Table of Contents
