Before You Begin - Nokia IP1200 Series Installation Manual

Before You Begin

To replace the accelerator card, you need:
Caution
To help guard against electrostatic discharge damage, make sure
you are properly grounded by using a grounding wrist strap and
following the instructions provided with the wrist strap before you
handle the components or open the appliance. If you do not have a
grounding wrist strap, make sure you are properly grounded before
you touch any electronic component.
Note
Because power to an IP1200 Series is automatically disconnected when
the chassis assembly is opened, you do not need to manually disconnect
the power for this procedure. Any servicing of the appliance, however,
should be completed with the chassis assembly fully removed from the
appliance.
To install the accelerator card
1. Use Nokia Network Voyager or Lynx to shut down the IP1200 Series.
Nokia IP1200 Series Security Platform Installation Guide
Physical access to the appliance
The Nokia encryption accelerator card and installation kit
Phillips-head screwdriver
Four screws (included in kit)
Disposable wrist strap (included in kit)
For information about how to access Network Voyager and the related
reference materials, see
Installing a Nokia Encryption Accelerator Card
"To open Nokia Network Voyager" on page 47.
135