Using Nokia Network Voyager To Manage Your Security Platform - Nokia IP1200 Series Installation Manual

Using Nokia Network Voyager to Manage Your
Security Platform
Use Nokia Network Voyager to configure and monitor your IP1200 Series.
For additional information about how to use Network Voyager, see
"Accessing Nokia Network Voyager Reference Information"
Network Voyager Inline Help"
To open Nokia Network Voyager
1. Start a Web browser on the host you plan to use to configure or monitor
2. In the Location or Address field, enter the IP address of the initial
Nokia IP1200 Series Security Platform Installation Guide

Using Nokia Network Voyager to Manage Your Security Platform

To connect Ethernet devices, use a straight-through RJ-45 cable to
connect to a 10-Mbps or 100-Mbps hub.
For details, see "Ethernet NIC Connectors and Cables"
To connect Gigabit Ethernet devices, use a fiber-optic cable with an LC
connector for each NIC interface. The destination end of the cable can be
either LC or SC, depending on the type of connector required for the
destination Gigabit Ethernet device.
For details, see "Fiber-Optic Gigabit Ethernet NIC Connectors and
Cables" on page 80.
To connect ISDN devices, use category 5E unshielded twisted pair cable
with an RJ-45 connector.
For details, see "ISDN NIC Connectors and Cables"
To connect X.21 devices, use X.21 DB-26 to X.21 adapter cable. To
connect V.35 devices, use V.35 DB-26 to V.35 adapter cable.
For details, see "V.35 and X.21 NIC Connectors and Cables"
your appliance.
interface you configured for the appliance.
on page 49.
on page 77.
on page 86.
on page 89.
and "Nokia
47