CLI Commands
The following table summarizes the equivalent CLI command for items in the Address Table/Dynamic Addresses page.
Command
show bridge bridge-group [interface] [address [mask]] [vlan
vlan-id] [sort {address | vlan | interface}]
Example
Console#show bridge 1
Interface Mac Address Vlan Type
--------- ----------------- ---- -----------------
Eth 1/11 00-10-b5-62-03-74 1 Learned
Console#
Address Aging
In the Address Aging page, you can specify the length of time an address stays available to the switch if it is not configured as static.
The Aging Time option sets the time before an address is purged from the system. You can change this value to any number between 10 and
1000000 seconds. (The default is 300 seconds.)
To save any changes you make in this page, click Apply Changes. If you don't want to save the changes, click Refresh.
CLI Commands
The following table summarizes the equivalent CLI command for items in the Address Tabled/Address Aging page.
Command
bridge-group bridge-group aging-time seconds
Example
Console(config)#bridge-group 1 aging-time 300
Console(config)#
Usage
Allows you to view classes of entries in the
bridge-forwarding database
Usage
Sets the aging time for entries in the address table