Introduction; Required Tools; Cautions Concerning Installation; Checking The Package Contents - Sony ACY-RK2 Operating Instructions Manual

Introduction

This Rack Mounting Kit can be used to mount the AIT
library in an EIA Standard 19-inch rack. For installation
instructions, contact Sony Service Support Center.
(Charges apply.)
Caution
Do not remove any screws other than those indicated
in this manual. Doing so may cause the AIT library
to fall, resulting in personal injury or damage to the
AIT library.
With a single drive installed, the AIT library weighs
approximately 18 kg / 39.7 lbs. (With two drives
installed, the AIT library weighs approximately 19
kg / 41.9 lbs.)
At least two people are needed in order to handle the
library. Handling the AIT library on your own could
result in back injury or other accidents resulting in
injury or damage to the AIT library.
Before beginning work, always press the power
switch on the rear to turn the power off, and then
disconnect all the cables.

Required Tools

The following tools are needed in order to mount the
Rack Mounting Kit:
• Philips screwdriver
• Standard screwdriver

Cautions Concerning Installation

Check the following points before mounting the AIT
library in a rack.
• Install the library in an operating environment with a
temperature range of 10 to 35 °C, and a humidity
range of 20 to 80 %. We recommend installing the
library in an indoor location where the temperature is
maintained between 15 and 25 °C.
• When installing the library, keep cables and other
obstructions away from the area around the fan on the
rear of the library and the ventilation holes on the front
of the library.
• When the library is mounted in a rack, the balance of
the rack could be affected and the rack could tip over.
To prevent this from happening, we recommend
securing the rack with brackets that are designed to
keep it from tipping over.
• Confirm that the correct power is being supplied to all
of the equipment in the rack.
• Confirm that the power outlet and power cord that you
are using are properly grounded.
• When installing the Rack Mounting Kit, take all
precautions necessary in order to prevent electrostatic
discharge while work is in progress, including using
anti-static mats and wristbands.
Checking the Package
Contents
After opening the package, make sure that all of the
following items are present. Contact your dealer if
anything is missing.
Rail assembly (2)
Bracket (4)
Side cover (2)
(4-658-406)
* Except with libraries that have a silver panel, use the side
covers that come with your libraries.
Rack mounting spacer
(4, 2 spare)
BAG ASSY SCREW (A-8013-297-A)
Type
Allen wrench
B cap
A screw (PSW4 × 14,
with washer)
B screw (PSW5 × 12,
with washer)
C screw (B4 × 10)
D screw (B4 × 5)
Introduction / Checking the Package Contents
L-shaped bracket (2)
Rail guides
(2, interchangeable)
Quantity
1
4
6 (2 spare)
8 (2 spare)
10 (2 spare)
10 (2 spare)
GB
11