Sony ACY-RK2 Operating Instructions Manual page 15

Mounting the Rail Assemblies on the
Brackets
1
Place a rail assembly in one set of brackets, slide the
rail assembly all of the way into the rack (1), and
then pull the slide rail out of the rail assembly (2).
Bracket
(2)
Slide rail
Note
If the rail comes in contact with the rack and does
not slide in and out smoothly, install the rail guides.
For information about how to install the rail guides,
see "When the Rack Obstructs Rail Movement"
(page 15).
2
Align the screw holes in the rail assembly with the
screw holes in the brackets, and then use a C screw
to secure the back end of the rail assembly to the
bracket.
When you use the S screw holes you do not need to
use nuts, so installation is easier. If you cannot use
the S screw holes, secure the screws with nuts.
The position is easy to determine if you push the
rail assembly all of the way into the rack so that it
is touching the post in the back of the rack. If the
screw holes do not line up, use the slot to the side of
the round screw hole to fasten the rail assembly to
the bracket.
Use this slot if the screw
holes do not line up.
Rail assembly
(1)
S screw hole
C screw
S screw hole
Rail assembly flush
against rack post
3
Push the slide rail back into the rail assembly, and
then use a C screw to secure the front end of the rail
assembly to the bracket.
If you use the slots for fastening, be sure to
carefully align the rack and the rail assembly before
tightening the screws.
4
Mount the rail assembly on the other side in the
same manner.
When the Rack Obstructs Rail Movement
Depending on your rack, the clearance between the
bracket and the rail may be so small that the rail comes
in contact with the rack, making the rail difficult to slide
in and out.
To remedy this problem, we recommend that you install
the supplied rail guides on the front brackets when
preparing the rack for the AIT library.
Slide rail
Bracket
Rack
Rack
1
Install the rail guides on the front brackets.
Install the rail guide so that it fits snugly against the
bracket, then secure it with a D screw (B4 × 5).
Each rail guide can be installed on the left or right
bracket. However, because the rail guides have a
slight bend at one end, make sure that you do not
install them inside out.
D screw (B4 × 5)
Small hole position
(relative to the screw hole)
• Right rail guide: under
• Left rail guide: above
Rail assembly
Slide rail
Obstruction
Rail guide snugly fitted
against the bracket
Preparation
15