Removing The Library From The Rack - Sony ACY-RK2 Operating Instructions Manual

4
Hand tighten the screw on one of the L-shaped
brackets on the front of the rack so that the library
is secured in place.
5
Hand tighten the screw on the other L-shaped
bracket the same manner.
6
Confirm that the library is housed properly in the
rack.
7
Attach the side covers on both sides of the library's
front.
Fit the side covers' A notches over the B caps and
push them as far as they will go in the direction of
the arrow.
A notch
Side cover
Once the library is mounted in the rack, connect the
power cord and the SCSI cables and make all
necessary settings as described in the operating
instructions (PDF).
Fastener
B caps
Side cover
Removing the Library
from the Rack
Caution
With a single drive installed, the AIT library weighs
approximately 18 kg/39.7 lbs. (With two drives
installed, the AIT library weighs approximately 19 kg/
41.9 lbs.)
At least two people are needed in order to handle the
library. Handling the AIT library on your own could
result in back injury or other accidents resulting in injury
or damage to the AIT library.
1
Turn off the library.
To turn the power off, press the power standby
switch on the front panel, and then press the rear
power switch.
2
Disconnect all of the cables.
3
Remove the side covers on both sides of the front
panel.
Side cover
4
Loosen the screws in both of the L-shaped brackets.
5
Pull the library out of the rack.
6
If necessary, remove the rail assemblies and
brackets from the rack.
7
If necessary, remove the inner rails and L-shaped
brackets from the library.

Removing the Library from the Rack

Side cover
17