Remote Operation; Install Batteries In The Remote Control; Operating In The Remote Control - Hitachi VT-DX815A Owner's Manual

REMOTE OPERATION

REMOTE OPERATION

Install batteries in the remote control

The remote control requires two "AA" batteries.
pic
1 Push the
of the arrow to remove it.
Note: When replacing the batteries, remove the old batteries and keep the
POWER button depressed for 10 seconds before inserting fresh batteries.
pic pic Hold for 10 seconds pic
2 Install batteries.
• Align the positive (+) and negative (-) polarity marks on the batteries with
those indicated on the remote control.
pic
3 Slide the cover in the direction of the arrow to close it.
pic

Operating in the remote control

Operating the VCR:
1 Make sure there is no obstacle between the remote control and
VCR's infrared receiver.
pic
Note: You cannot operate the VCR if there is an obstacle (for example, coffee
table, sofa, etc) between the VCR and remote control.
2 Point the remote control at the VCR's infrared receiver and press
the required button on the remote control.
Note: If the remote does not work even at close range, try replacing the batteries
with two fresh "AA" batteries.
About the illuminated buttons:
• If a button on the remote control is pressed, one of the VCR, TV and
DSS buttons lights so that you know which device you are now operating.
pic
mark and hold it, then slide the cover in the direction
14