Table of Contents
Advertisement
Command Specifications
c.
TB (transfer block)
"1": Data blocks which contain errors that are impossible to correct are
"0": Data blocks which contain errors that are impossible to correct are not
d.
RC (read continuous)
This bit specifies continuous transfer of all the data requested by a command
unaccompanied by a delay for executing error recovery processing.
The IDD disregards the specification in this bit and operates according to the
default value (=0).
e.
EER (enable early recovery)
"1": When a correctable data check has been detected, data correction
"0": When a correctable data check has been detected, retry (rereading) is
The IDD disregards this bit and operates according to the default value (=1).
f.
PER (post error)
"1": When several errors (errors related to the disk drive), which were
"0": Even when several errors (errors related to the disk drive), which were
g.
DTE (disable transfer on error)
"1": Even when several errors on the disk drive, which were recovered from
"0": When several errors on the disk drive, which were recovered from
The IDD disregards this bit and operates according to the default value (=0).
4-28
transferred to the INIT during a read operation.
transferred to the INIT during a read operation.
according to the ECC is applied immediately without executing retry
(rereading) up to the number of times specified in the "Number of retries
during READ" parameter.
executed up to the number of times specified in the "Number of retries
during READ" parameter, then data correction according to the ECC is
applied if possible.
recovered from normally through the IDD's error recovery processing,
have been detected, a CHECK CONDITION status is reported when
execution of that command is completed. In the sense data generated at
this time, the sense key indicates "RECOVERED ERROR [=1]" and the
content of the final error to be corrected successfully is reported.
recovered from normally through the IDD's error recovery processing,
have been detected, that command is completed with a GOOD status and
the contents of the recovered errors are not reported.
normally through the IDD's error recovery processing, have been
detected, execution of that command terminates at that point.
normally through the IDD's error recovery processing, have been
detected, execution of that command is continued.
C141-C009
Advertisement
Table of Contents
