Fujitsu MAU3147RC SERIES Technical Manual page 349

Table 5.5 Sense data error classification (3/3)
K* C* Q*
6 29 xx Power on, reset, or HARD RESET occurred
The IDD was initialized by a Power on or HARD RESET
sequence.
6 2A 01 Mode parameters changed
The MODE SELECT parameters were changed by
another INIT.
6 2F 00 Commands cleared by another INIT
Commands were cleared by another INIT.
6 3F 01 Microcode has been changed
02 Changed operation definition
7 27 00 Write protected
Access to a read protected or write protected.
B 03 xx Peripheral device write fault
11 xx Unrecovered read error
13 xx Sync byte not found for data field
14 xx Record not found
15 xx Mechanical positioning error
B 0E 02 Information Unit Too Long
47 01 Information Unit iuCRC Error Detected
4B 01 Invalid Target Port Transfer Tag Received
4B 02 Too Much Write Data
4B 03 ACK/NAK Time Out
4B 04 NAK Received
4B 05 Data Offset Error
An unrecoverable SAS related error occurred in the
command execution sequence.
B 4E 00 Overlapped commands attempted
Before execution of a command was completed, a new
command was issued by the same INIT.
4D nn Tagged overlapped commands
E 1D 00 Miscompare during verify operation
Data failed to match in the Byte check mode of the
Verify command.
* K: Sense Key
Q: Additional Sense Code Qualifier
C141-C009
5.2 INIT Error Recovery Methods (Recommended)
Outline of Error
C: Additional Sense Code
L: Logging Necessary? (shown in Section 5.2.3)
Recovery Method
L*
(See Table 5.6.)
None 14
None 21
None 25
None 27
None 15
Need 12
Need 6
None 2
None 24
5-19