Important Safety Information - Electrolux EN18WI30LS Service Manual

Important Safety Information

To prevent damage to property and injury to the user, the icons below warn of
varying levels of risk.
Ignoring this indication will cause an immediate danger of death or
Warning
serious injury.
Caution
Ignoring this indication may result in death or serious injury.
Prohibited.
1. Safety Tips for Service
• Wear the appropriate clothing and protective gear:
Caution
• Use only the appropriate tools and parts:
Warning
• Modi cation of the unit is prohibited:
• When servicing:
Warning
• Do not short circuit any safety device on this appliance:
• Exhaust and gas leakage caution:
Warning
2. Post-Service Checks
• Check parts for leaks:
Caution
• Check for combustibles:
Caution
• Check insulation resistance:
Warning
• Properly reconnect the power supply:
Warning
In order to prevent injury or accident, wear a protective helmet, safety boots and a
lifting belt whenever necessary.
Only use replacement parts manufactured by Electrolux for this model as listed in the
Installation Manual Parts List for service on this unit. Use appropriate tools.
Do not attempt to modify or alter the unit. This will cause a fire hazard and a risk of
electrical shock.
Disconnect the power supply during maintenance and repairs to reduce the risk
of electric shock. If it is necessary to have the electricity connected during repairs,
use extreme caution not to touch parts that may cause a shock.
If a safety device is not functioning properly, replace the part. Do not under any cir-
cumstances short circuit the part.
Always check for leaks when installing or modifying the exhaust vent or gas piping.
Confirm that there are no gas, water, or exhaust leaks regardless of whether the
service performed could have caused them.
If the unit is installed indoors, check that the flue collar and vent pipe are installed
correctly and that they are in good condition. Confirm that there are no gas, water
or exhaust leaks regardless of whether the service performed could have caused
them.
After service or maintenance is completed, check that there are no combustibles in
the vicinity of the unit.
After service or maintenance is completed, measure the resistance between the
electrical wires and ground. If it is less than 10M Ω, there is a risk of electrical
shock.
Confirm that the power supply has been reconnected properly after service or
maintenance is completed. Also confirm that there is no dust or other obstacles
that might cause an electric shock or a fire hazard.
2