Note - Siemens SATURN IIE EPABX Installation Test Procedures

SATURN IIE EPABX
Installation Test Procedures
Dashed lines represent installation-dependent cross-connectrons
Maximum of one code calling equipment (with or without answerbaclc
can be interfaced with the system.
When maintenance procedures are to be performed on code callrng equip-
ment, associated trunk circuit must first be taken out-of-service. Failure
to observe this will cause users accessing code calling to receive unan-
swered ringback tone instead of busy tone.
Figure 6.12
Notes: Dashed lines represent installation-dependent cross-connections,
Maximum of four DTMF dial dictation circuits can be interfaced with the
s y s t e m .
When maintenance procedures are to be performed to a dial dictation equip-
ment, the associated SLMA
to observe this will cause users accessing the dial dictation equipment to
hunt an out-of-service device and receive unanswered ringback tone
instead of being routed to an in-service device or receiving busy tone.
Connecting Block
Code Cailing (With or Without Answcrba~h) Cross-Comedons
must first be taken out-of-servrce.
Figure 6.13 Dial Dic?ation (DTMF) Cross-Connections
System T&R Connecting Block
System MDF Cable J32, J34,
J36, J38, J4.0, J42 or J44 from the
Basic shelf or J25, J28, J30, J32,
J34, J36, J38, or J40 from the LTU
s t e m MDF Cable J32, J34, J36, J38,
, J42 or J44 from the Basic shelf or
, J28, J30, J32, J34, J36, J38, or J40
m the LTU shelf
Issue
1, May 198G