Fujitsu Eternus DX60 User Manual page 111

Chapter 6 Cable Connection
> 6.3 Fibre Channel Cable Connection (For Fibre Channel)
Fibre Channel cable connection procedure
The following explains how to connect the Fibre Channel cable.
This section explains how to connect the Fibre Channel cable to the ETERNUS DX60/DX80. For
the ETERNUS DX90, each controller has four Fibre Channel ports.
IMPORTANT
P3AM-3042-06ENZ0 ETERNUS DX60/DX80/DX90 Disk storage system User Guide
• Fibre Channel cable is thin and breaks easily, so be careful not to
CAUTION
pinch the cable between devices or bend it too much. Keep a 30mm
or larger radius when bending Fibre Channel cable. Failure to do so
may cause device damage or failure.
• To help with Fibre Channel cable management and prevent incorrect
connections, attach labels to the Fibre Channel cables and make a note
of connection origins and destinations.
• When connecting the Fibre Channel cable, check the direction of the
connector tab and insert it all the way in firmly.
When disconnecting the Fibre Channel cable, pull out the connector
while holding its tab.
This section describes dual controller model as an example. Note that there
is only controller 0 (CM#0) for single controller model.
30mm
or larger
90˚
Do not bend square
111
Do not bind up
Copyright 2010 FUJITSU LIMITED