Type Controller Enclosure; Front View; Figure 2.11 Front View Of 2.5" Type Controller Enclosure (With Flange Cover) - Fujitsu Eternus DX60 User Manual

Chapter 2 Components
>

2.2 2.5" Type Controller Enclosure

2.2 2.5" Type Controller Enclosure
The 2.5" type controller enclosure contains 2.5" disks installed in the front, and controller mod-
ules and power supply units (with fans) in the rear.
2.2.1

Front View

With flange cover
Flange cover

Figure 2.11 Front view of 2.5" type controller enclosure (with flange cover)

P3AM-3042-06ENZ0 ETERNUS DX60/DX80/DX90 Disk storage system User Guide
DISK READY LED
Glows ( ) or blinks green (
are operating normally.
DISK FAULT LED
Glows orange ( ) when a disk has failed.
Blinks orange ( ) according to the VDS (Microsoft Virtual Disk Service) commands.
Disk
Up to 24 disks can be installed in the ETERNUS DX60/DX80/DX90.
POWER LED
Glows green ( ) when the power is
turned on.
READY LED
Glows green ( ) when device is available
for use.
FAULT LED
Glows orange ( ) when an internal device
part abnormality has been detected.
Blinks orange ( ) when a device part which
needs preventive replacement has been
detected.
IDENTIFY LED
Blinks blue ( ) or turns off ( ) as ordered
via GUI to identify the enclosure installation
locations.
CACHE LED
Glows green ( ) when there is data in the
device cache.
Blinks ( ) when a power failure has
occurred and the cache data is being saved
to flash memory.
Power switch
Used to turn the device
ON and OFF.
57
) when disks
Copyright 2010 FUJITSU LIMITED