Fujitsu Eternus DX60 User Manual page 194

Chapter 8 Installing Optional Products
> 8.2 Drive Enclosure Installation
4
5
6
P3AM-3042-06ENZ0 ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Bracket L
Screw holders
M5 screws
(Front rack pillars)
M5 screws
The four M5 screw positions for the rack rails (brackets) are determined relative to the
drive enclosure base line.
The M5 screws should be inserted in the 1st and 3rd holes above the base line.
[Left]
3rd position
2U
Drive enclosure
(M5 screws)
1st position
(M5 screws)
Base line of
drive enclosure
Rack rails
(Brackets)
Tighten the M4 screws of the rack rails (brackets) that were slightly unscrewed in
Step 2.
For 3.5" type drive enclosures, remove the front cover.
For details on how to attach the front cover, refer to
Cover" (page 75).
Install the drive enclosure in the rack.
CAUTION
•
Screw holders
(Rear rack pillars)
Bracket R
Screw holders
[Right]
3rd position
(M5 screws)
1st position
(M5 screws)
"3.3 Attaching and Removing the Front
Do
When installing or removing the drive enclosure to or from the
rack, make sure to have the right and left sides and the
bottom of the drive enclosure by two or more people. Failure
to do so may cause injury.
194
M5 screws
M5 screws
Screw holders
Copyright 2010 FUJITSU LIMITED