Connecting Dolby 5.1, Tv, Vcr And A/V Receiver - Motorola DCT2000 Installation Manual

Connecting Dolby
A / V Receiver
1
Connect an RF cable between the cable wall outlet and the CABLE IN
connector on the DCT2000.
2
Connect the RF coaxial cable, supplied with the DCT2000, between the
RF IN and TO RF IN connectors on the DCT2000.
3
Connect an optical audio cable between the OPTICAL connector on the
DCT2000 and the OPTICAL connector on the A / V receiver.
4
Connect a stereo audio cable between the VCR AUDIO OUT R and L
connectors on the A / V receiver and the INPUT AUDIO R and L
connectors on the stereo VCR.
5
Connect a video cable between the VIDEO connector on the DCT2000
and the CABLE / TV VIDEO connector on the A / V receiver.
6
Connect a stereo audio cable between the OUTPUT AUDIO R and L
connectors on the stereo VCR and the AUDIO VCR IN R and L connectors
on the A / V receiver.
7
Connect a video cable between the INPUT VIDEO connector on the stereo
VCR and the VIDEO VCR OUT connector on the A / V receiver.
8
Connect a video cable between the OUTPUT VIDEO connector on the
stereo VCR and the VIDEO VCR IN connector on the A / V receiver.
9
Connect a video cable between the INPUT VIDEO connector on the stereo
TV and the TV / MONITOR OUTPUT VIDEO connector on the A / V
receiver.
Cable connections marked with an * are optional. These connections allow the
use of the DCT2000 and TV without powering-on the VCR and A/V Receiver.
The optional connections are:
•
Connect a RF coaxial cable between the TO TV / VCR connector on the
DCT2000 and the CABLE / ANTENNA IN connector on the stereo VCR.
•
Connect a RF coaxial cable between the To TV connector on the stereo
VCR and the CABLE / ANTENNA IN connector on the stereo TV.
When using the Dolby
audio connections to the A / V receiver are not used.
5.1, TV, VCR and
®
®
5.1 optical output, the SPDIF and left / right baseband
2 5