Starting And Terminating The Icu (For A Pc Using Windows Nt) - Fujitsu 5000 Series User Manual

Starting and terminating the ICU (For a PC using Windows NT)

This section explains how to start and terminate the ICU using Windows NT.
1
If the PC is turned on, turn it off.
2
Confirm that the "boot disk" is in write-enable status, insert in the floppy disk drive, then
turn on the PC.
MS-DOS is started.
3
Confirm that the "Plug and Play kit for MS-DOS(R) ICU R1.21 disk 1" is in write-enable status,
replace the disk with the "boot disk", then enter the following character string and press
the [Enter] key:
icu
The ICU is started.
Point
- Do not remove the "Plug and Play kit for MS-DOS(R) ICU R1.21 disk 1" from the floppy disk
drive when using the ICU.
- Use the keyboard for all ICU operations.
- Do not set the PCI devices to "Disabled" with the ICU. The devices may not be reset to "Enabled."
4
Set up the resources.
When resource setup is terminated, terminate the ICU.
5
Press [Alt]+[F].
The pull-down menu appears.
6
Select the "Exit" command and press the [Enter] key.
7
Turn off the PC main unit.
30