Bosch Solution 16i User Manual page 32

Solution16 User Guide
i
Display Trouble Condition
Mains Missing
POWER
Flashing
Battery Low
BAt_Lo
No BAt Battery Missing
RFlost RF Rxer Missing
RF Rxer Tamper
RF TPR
RF Rxer Jammed
RF JAM
Comms Trouble R1
RoVte2
Comms Trouble R2
RoVte1
FAiL Comms Test Fail
BusTrb Buss Trouble
DEFPiN Default PIN Trbl
Date And Time
DATE
Cabinet Tamper
CABTPR
CONTRB Siren Trouble
no Tel Telco Line Trouble
LAn OL LAN Overload
Comm+ Overload
COM OL
Accessory Overld
Acc_OL
SErviC Time For Service
EE rom Memory Fault
Service Mode
SERViC
PHONE
Phone In Use
32
The system has detected that the AC mains supply has failed or is disconnected. If
there is not a general power outage in your suburb then you should contact your
security company.
The backup battery has failed the periodic test which the system performs on a
regular basis. You should contact your security company as the battery may need
replacing.
The system has detected that its backup battery has been disconnected.
The system has detected that the RF receiver is disconnected.
The system has detected that the tamper circuit on the RF receiver is faulted.
The system has registered a jamming fault from the RF receiver. This situation may
preven certain parts of your system from working correctly. You should contact your
security company.
The system has failed to send reports to the primary report contact. You should
contact your security company.
The system has failed to send reports to the secondary report contact.
You should contact your security company.
The system has failed to send its periodic report to the monitoring station.
You should contact your security company.
The system has failed to communicate to a system device (e.g. keypad etc).
The system has detected that either the Installer PIN or User 1 PIN has not
been changed from the factory default codes. These codes should be changed
immediately to prevent a security risk.
The system date and time needs to be set.
The system has detected that someone has tampered with its metal enclosure or that
it has been forced open. Inspect and contact your security company if necessary.
The system has detected that the external siren has failed or has been disconnected
from the system.
The system has detected that its telephone line has been disconnected for a
minimum of 30 seconds.
The system has detected that the current load has exceeded the maximum LAN
rating. You should contact your security company.
The system has detected that the current load has exceeded it's maximum COMM+
rating. You should contact your security company.
The system has detected that the current load has exceeded it's maximum ACCS+
rating. You should contact your security company.
The system displays this trouble condition to remind you that a service call is due.
The system has detected an error with its internal memory. You should contact your
security company.
The security installer has entered service mode.
The phone in use ICON will come on when the system is using the phone line.
Table 14: Trouble Messages
Description
Bosch Security Systems 10/07 BLCC500U FTR1.01