Page 6
◗ Check the cord regularly for possible damage. ◗ If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard.
◗ This appliance is intended for household use only. Before first use Release the carry case (HI575/571 only). Remove the carry case (HI575/571 only). Remove any sticker or protective foil from the soleplate and clean the soleplate with a soft cloth.
ENGLISH Preparing for use Fastening the stand clamp Fold out the clamp on the bottom of the stand and fix the stand clamp to the ironing board or to another stable surface, such as a tabletop. The rubber feet on the bottom prevent the stand from slipping. ◗...
Page 9
ENGLISH Setting the temperature Put the iron on the iron stand. Set the required ironing temperature by turning the temperature dial to the appropriate position (see section 'Tips' for extra information). Check the laundry care label for the required ironing temperature: Symbol on Type of fabric Temperature...
Set the mode switch to position ∫ (cordless ironing). Take the iron from the stand. HI575 only: put the iron back on the stand when the temperature light starts blinking.This indicates that the iron has cooled down below the set temperature.
Page 11
ENGLISH ◗ When you use the shot-of-steam or turbo-steam function, the iron may cool down rather quickly.We advise you to iron in corded mode when using these functions. Steam ironing Make sure that there is enough water in the water tank. Select the recommended ironing temperature (see section 'Setting the temperature').
Page 12
Electronic safety shut-off function (HI575 only) The electronic safety shut-off function automatically switches the iron off if it has not been moved for a while.
ENGLISH ◗ To indicate that the heating element has been switched off, the auto-off light will start blinking and you will hear an audible signal. - In horizontal position, this will happen after 30 seconds. - In vertical position, this will happen after 8 minutes. ◗...
ENGLISH Do not pour vinegar or other descaling agents into the water tank. Put the iron on its stand. Set the temperature dial to MAX. Put the mains plug in the wall socket. Set the mode switch to position ∫ (cordless). Wait until the temperature light goes out and then remove the iron from the stand.
Page 15
◗ You can wind the cord round the stand and fix the end of the cord with the cord clip. Place the carry case over the stand (HI575/571 only). Press on the case to lock it onto the stand ('click') (HI575/571 only).
By doing this you will help to preserve the environment. Guarantee & service If you need information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet).