Tuning A Station - Silvercrest LT 710 User Manual And Service Information

SilverCrest LT 710

Tuning a Station

When powering the device on for the first time, no station has been stored.
The setup wizard for DVB-T mode will open automatically. The display
language will still be the factory-default language.
The left button has to be highlighted in yellow. Press the OK button
(20) to launch the setup wizard. You may select a different display
language in the next step, if necessary.
Another window will appear where you may select the country where
you are going to use the unit. The language and time zone will be set
automatically according to the selected country. However, it is
possible to select a different display language later on.
Navigate to the "NEXT" button and then press OK (20) to proceed
with the next step.
Confirm the "YES" button by pressing the OK button (20) to start the
automatic channel search. Or select "NO" to quit the setup wizard
without performing a channel search.
The automatic channel search begins. This process may take a few
minutes. During this process, the display will show the progress.
Furthermore, all TV and radio stations found so far will be listed.
When the channel scan is completed, the menu will close and the
last found channel will be shown.
English
15