Brother MFC-8510DN User Manual page 103

Error Message
Drum Stop
Duplex Disabled
Faxability On
(For New Zealand)
Fuser Error
Jam Duplex
Jam Inside
Jam MP Tray
Jam Rear
Jam Tray 1
Jam Tray 2
Limit Exceeded
Log Access Error
Manual Feed
No HUB Support
Cause
It is time to replace the drum
unit.
The back of the machine is not
closed completely.
The machine is set to
Faxability mode. You can not
change the Recieve Mode from
Manual to another mode.
The temperature of the fuser
unit does not rise to a specified
temperature within the
specified time.
The fuser unit is too hot.
The paper is jammed in the
duplex tray or the fuser unit.
The paper is jammed inside the
machine.
The toner cartridge is placed in
the machine without the drum
unit.
The paper is jammed in the MP
tray of the machine.
The paper is jammed in the
back of the machine.
The paper is jammed in the
paper tray of the machine.
The number of pages you are
allowed to print has been
exceeded. The print job will be
cancelled.
The machine could not access
the print log file in the server.
Manual was selected as the
paper source when there was
no paper in the MP tray.
A USB hub device is
connected to the USB direct
interface.
Action
Replace the drum unit.
(See Replacing the drum unit uu page 76.)
Close the back cover of the machine.
Set FaxAbility to Off.
(See FaxAbility uu page 37 .)
Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine
idle for 15 minutes with the power on.
See Paper is jammed in the duplex tray
uu page 112.
See Paper is jammed inside the machine
uu page 108.
Put the toner cartridge into the drum unit, and
then re-install the drum unit and toner cartridge
assembly in the machine.
See Paper is jammed in the MP tray
uu page 103.
See Paper is jammed at the back of the
machine uu page 105.
See Paper is jammed in paper tray 1 or tray 2
uu page 104.
Contact your administrator to check your
Secure Function Lock Settings.
Contact your administrator to check the Store
Print Log to Network settings.
For detailed information uu Network User's
Guide: Store Print Log to Network
Place paper in the MP tray. If the machine is in
Pause mode, press Start.
(See Loading paper in the multi-purpose tray
(MP tray) uu page 12.)
Disconnect the USB hub device from the USB
direct interface.
Troubleshooting
B
95