Adjustment Of Paper Aligning Value; Registration Adjustment - Toshiba 2060 Service Handbook

1.5.2

Adjustment of paper aligning value

If necessary, you can extend the feed roller life slightly by increasing the paper aligning value.
<Procedure> (Use code 80~83 or 92~96 in the "05" mode.)
(1)
0 5 8 0
(Cassette)
PWR
C
E/S 0
(To copy)
(2) Check the copy for image void and if there is
any, reduce the new value to 14, 13, ... until
no void occurs. Check for paper misfeeding.
When the aligning value is increased, noise
caused by the paper scraping against the
mylar may possibly be increased.
(3) For the LCF, ADU and pedestal, the same pro-
cedure can be used.
Notes: 1. When frequent paper jams occur near the aligning roller by using special thin paper other than specified,
the aligning value can be changed (reduced) as a measure. However, when the aligning value is reduced
excessively, this may possibly cause the registration to be shifted. Therefore, make sure that no registra-
tion shifting occurs while adjusting the value.
2. Long size adjustment is used as the base when there are both long and short adjustments.
1.5.3

Registration adjustment

Incorrect registration (or top margin) may occur due to paper quality, feed roller surface condition, etc.
besides, misadjustment. Check these items before starting adjustment.
Note: When the adjustment value of the cassette is changed, the registrations by all the other feedings will be
shifted correspondingly. Therefore, be sure to check all other registrations after the cassette adjustment.
However, each adjustment other than the cassette can be performed individually.
Cassette (lower)
100% 200% 50%
(53) (54) (55)
Dec. 1996 © TOSHIBA CORP.
PRINT 08
(Current value) (New value)
9
Void
Manual feed
100%
(56)
1 - 25
Cassette
1 5
INT
ADU
100%
(59)
2060, 2860/70 ADJUSTMENT
C