Toshiba 2060 Service Handbook page 5

Group
Service call by the paper feeding
system
Service call by the optical system
Service call by the process system
Fuser unit area
Service call by communication
Service call by ADF
Service call by sorter
Service call by the other
Note: If there is a possibility of the heater malfunctioning as a consequence of the short-circuiting of the triac, the
microcomputer will check for abnormal temperature and send out error code "C44" and turn off the main
switch of the copier.
2060, 2860/70 ADJUSTMENT
Error code
C11 Abnormal operation of the ADU side motor
C12 Abnormal operation of the ADU end motor
C13 Abnormal operation of the upper cassette tray
C14 Abnormal operation of the lower cassette tray
C15 Abnormal operation of the PFP upper cassette tray
C16 Abnormal operation of the PFP middle cassette tray
C17 Abnormal operation of the PFP lower cassette tray
C18 Abnormal operation of the LCF tray
C21 Carriage initialize error
C22 Lens initialize error
C23 Mirror initialize error
C26 Exposure lamp burn out detected
C33 Easy set-up is failed
C35 Developer material exist at the transfer/separation adjustment
C41 Abnormal thermistor or heater disconnection when power is on
C43 Warming up mode after disconnection judgement, or abnor-
mal thermistor after ready
C44 Warming up mode after disconnection judgement, or heater
disconnection after ready
C45 Sub thermistor is open-circuited
C54 Sorter — Main CPU communication error
C55 ADF — Main CPU communication error
C56 PFC — Main CPU communication error
C72 Poor adjustment by the aligning sensor detected
C73 EEROM poor initialized
C74 Poor adjustment by the exit/reserve sensor detected
C81 Paper transport motor abnormal
C82 Bin shifting motor abnormal
C83 Upper limit error
C84 Lower limit error
C85 Home sensor error
C86 Staple guide bar drive motor abnormal
C87 Staple drive motor abnormal
C88 Copy removal sensor error
C93 ADF original stop signal not received
1 - 2
Machine status
Dec. 1996 © TOSHIBA CORP.