Additional Information; Programming The Remote Control - Toshiba HDR5010KB Owner's Manual

Additional Information

Programming the Remote Control

The Digital TV recorder's remote control can be programmed to operate certain TVs.
Follow the procedure below to programme the remote control.
TV standby
button
0-9 buttons
AD button
GUIDE
button
1. Find the 3 digit code for your brand of TV from the brand codes, starting on page 46.
If your brand is not included in the list or the codes for your brand do not operate your equipment, refer
to the following page for an automatic method of programming the remote control.
2. Press and hold the
button flashes twice and lights ON.
3. Use the [0]-[9] buttons to enter the 3 digit code for your brand. The [ TV] button
flashes when each digit of the code is entered.
4. If a valid code has been entered, the
goes off.
5. Check that the remote control operates your equipment by pressing the
If not, repeat the above procedure and try another code for your brand.
The codes you enter may be lost if weak batteries are not replaced immediately. Even if your TV brand is
listed in the code table, in some instances it may not be possible to operate all of the available functions.
40
HDR5010 User Guide.indb 40
[ ] button and the [AD] button for 3 seconds, then the [ TV]
[ TV] button will flash twice, slowly and then
button
[ TV] button.
8/6/10 09:08:30