Sony HDMI VPL-BW5 Operating Instructions Manual page 40

SeUing items Functions
Initial setting
Color System
Selects the color system of the input signal.
Auto
If you select "Auto," the projector detects the color
system of the input signal automatically. If the
picture is distorted or colorless, select the color
system according to the input signal.
Power Saving
Selects the Power Saving mode.
Off
Lamp off: The lamp goes off if no signal is input for
10 minutes. The lamp lights again when a signal is
input or any button is pressed.
Standby:
The projector goes into Standby mode if
no signal is input for 10 minutes. To use it, tum on
the power again.
Off: The projector does not go into Power Saving
mode.
IR Receiver
Selects the remote control detectors (IR Receiver)
Front & Rear
on the front and rear of the projector.
Front
&
Rear: Activates both the front and rear
detectors.
Front:
Activates the front detector only.
Rear:
Activates the rear detector only.
Lamp Timer
When replacing the lamps, reset the lamp timer.
-
Reset
1m
• Press APA when the full image is displayed on the screen. If the projected image includes a black
portion around it, the APA function will not work properly and some parts of the image may not
be displayed on the screen. .
- You can cancel the adjustment by pressing APA again while "Adjusting" appears on the screen.
- The picture may not be adjusted properly depending on the type of input signal.
- Adjust the "Dot Phase," "H Size," and "Shift" items in the INPUT SETTING menu when you
adjust the picture manually.
• If the input signal is not displayed correctly when "Input-A Signal Sel." is set to "Auto," set it to
conform the input signal.
40