Cleaning And Maintenance; Cleaning; Maintenance / Removing / Assembling The Cutting Blade; Special Accessories - Silvercrest SAS 150 A1 Operation And Safety Notes

Cleaning and maintenance

Cleaning and maintenance
Q

Cleaning

Q
Important safety advice for
cleaning the slicer
1. Before starting to clean the electric Multi-Pur-
pose Slicer; switch it off, remove the power ca-
ble from the mains socket and set the food
8
support plate into the "0" setting.
13
2. Do not submerse the electric Multi-Purpose
Slicer in water.
ATTeNTION! RISk OF SeRIOUS
3.
INjURy: The cutting blade
Accessories suitable
for dishwashers!
C lean the food carriage
plate , the cutting blade
11
tray in the dishwasher.
17
I t is necessary to clean the electric Multi-Pur-
pose Slicer thoroughly at regular intervals as
perishable food scraps could accumulate on
the appliance or behind the cutting blade
C lean all appliance parts not suitable for the
dishwasher with a lightly moistened cloth.
Wipe off the appliance housing
blade covering
6
guide slots and the food support plate
9
carefully. Do not use abrasive cleaning agents,
sponges with rough surfaces or hard brushes.
Cleaning brush:
ATTeNTION! RISk OF peRSONAL INjU-
Ry! Carry out all tasks using the cleaning brush
(see Fig. F) with great care. Should it slip
19
close to the cutting blade
of receiving a severe personal injury.
U se the bristles of the cleaning brush
move remnants such as crumbs from all difficult
to reach positions. The flattened end can be
excellently used to remove stubborn soiling.
10 GB/IE/CY
is very sharp!
12
, the food holder
10
and the slice
12
, the cutting
5
, the support table with
, there is the risk
12
to re-
19
Maintenance / Removing /
Q
assembling the cutting blade
Important safety notices for
the removal and assembly of
the cutting blade!
1. Switch the slicer off, remove the plug from the
power socket and set the food support plate
into position "0".
2. ATTeNTION! RISk OF peRSONAL
INjURy! The cutting blade
For the removal and assembly wear appropriate
safety gloves. Otherwise, you could receive cut
injuries.
O pen the blade cover
blade cover unlock button
blade cover
R emove the plastic screw clip
mounting (see Fig. E) and screw the blade lock
of the cutting blade
the left.
W hen taking out the blade
you grasp it at its centre.
. T he cutting blade
12
dishwasher.
C lean the housing behind the cuttingblade
with a dry cloth or a soft brush.
R e-assemble the cutting blade
sequence of the above instructions.
13
D ue to the special sawtoothing and the high
quality, the cutting blade
sharpness for a very long time. A resharpening
of the cutting blade is not necessary. Consult
the service centre for your country if you have
questions about the cutting blade

Special accessories

Q
Round cutter:
An untoothed cutting blade, specifically for the
finest of slices, is also available.
Orders for special accessories are be directed to
the service centre for your country.
is very sharp!
12
by pressing the
6
. Remove the
4
.
6
from the
18
out by unscrewing it to
12
make sure that
12
can be cleaned in the
12
in a reverse
12
will retain its
12
12
13
12
.