Hitachi AJ-S60TXP User Manual page 10

Installation Guide (continued)
1
Connect the water drainage hose with the
water drainage joint on the back of the
body.
•
Fully insert it into place to avoid leakage.
Water drainage joint
3
1Insert the fi xing holder of
water drainage hose into
mounting hole.
2As shown in illustration,
rotate the fi xed leg for 90
degree into hole.
1Insert
2Rotate
Attention
•
To avoid direct draining due to the fallen water drainage hose, the water
drainage hose must be used only after installing into fi xing holder, and its
hanging height should not exceed 1m.
•
Do not release the water drainage hose lest the water is splashed.
•
Do not use extended water drainage hose.
•
Do not immerse the U-shaped hose on the tail of the water drainage hose in
the water.
U
•
When using it in winter, to prevent icing, please release the water drainage
hose after using and place the its tail in water container such as basin, set
the washer to single dehydration mode and drain the remained water.
•
Be sure not to install the water drainage hose at a position lower than water
drainage joint, otherwise, it could lead to diffi culties in water drainage.
This discharge pipe installs the method to be only suitable in AJ-S60TXP.
AJ-S60TXP
10
How to Install the Water Drainage Hose
Water drainage hose
4
Pull the water drainage
hose straight, concave
to fi x into the fi xing
holder of water
drainage hose.
90
Fixing holder
1
AJ-S60TXP
2
After the connection is completed, please
use hose clipper to clamp the water
drainage hose to avoid fall-off.
Water drainage hose from the right or (left) side
of the unit.
Concave
40
40
Hose Clipper
1m
Unplug U-shaped
hose and insert
into water
drainage hose.
U
Water drainage hose