Hitachi AJ-S60TXP User Manual page 46

When Failure Happens (continued)
Case
Sprinking rinsing turns into water
storing rinse.
About
When the washings is not much,
the rinse
water can't be poured over the
clothes in sprinking rinising mode.
Supply water during the course
About the
of spinning.
spinning
Supply water and start rinsing
during the course of spinning.
Spin intermittently after start
spinning.
The lid can't be opened even
when the Pause button is
pressed during the spinning.
The power supply switch won't work
right away even when the On/Off
button is pressed during the spinning.
During the period of water drainage,
AJ-S60TXP
the water drainage pump start to
About
work, and there is water drained out
from the water drainage hose.
the water
drainage
pump
It sounds like asthma when the
water drainage pump start to work.
Relatively low water level
compared with the washings
load.
About
the water
level
Relatively high water level
compared with the washings load.
About
the lint
There are much fl oss.
fi lter
About the
Washing doesn't fi nish beyond
washing
the predefi ned time.
duration
46
Cause
•
It is because the clothes oblique cause the action of the
security switch.
•
It doesn't matter that the water is hard to be poured over the
clothes since there are not much washings.
•
The security switch acts as the laundry declines.
Change automatically to the "Water-storage rinse" for the next rinsing.
•
The security switch acts as the laundry declines.
Start spinning and agitating after rinsing, and the spinning will
go on after clearing the laundry declination.
•
It is because the sensor control the spinning times to improve
the effi ciency of spinning.
•
When the power supply is cut off, the spinning basket stops
completely, and the lid lock will be unlocked.
•
The power supply switch won't work until the spinning basket
stops the inertial rotation.
•
This is to prevent overfl ow.
The water drainage pump starts automatically when the preset
alarming level is exceeded.
•
This is because the water in the washer is going to to be drained off,
resulting in the entry of air into the chamber of the water drainage pump.
•
The setting of the water level is based on the extent of the washings
in the washing machine emerging out the water surface and the
ability of the clothes roll up and down in the washing machine.
•
Since the clothes of chemical fi ber is comparatively light, the
water level is set accordingly low.
•
The water level will rise during washing if the clothes being washed
have been drenched or water has been charged in advance.
•
If there is much fl oss in "Normal" process, the effi ciency of the fl oss
filtering can be improved by increasing the water consumption,
extending washing time and setting rinse for more times.
•
The washing time may exceed predefi ned time in case of extremely
small amount of charged water.