Desktop Control Utility 1.0 - NEC LT265 Network Manual

1. What You Can Do with User Supportware 2

1-2. Desktop Control Utility 1.0

Desktop Control Utility 1.0 is software that operates the desktop screen of a personal com-
puter at a remote location from the projector by using a network.
A commercially available USB mouse is connected to the projector to operate the per-
sonal computer.
Suppose, for example, a PowerPoint file to be presented in a conference is saved to a
personal computer in your office. If this personal computer is connected to the projector
in the conference room with LAN when the conference is held, the desktop screen of the
personal computer in your office (Windows 2000/XP) can be projected and the Power-
Point file can be presented by operating the projector. In other words the personal com-
puter does not need to be brought into the conference room.
Conference room
Important
•
You can use the Desktop Control Utility 1.0 to operate a personal computer located in a
separate room from the projector over a network. Therefore, care must be exercised to
prevent any third party from viewing the screen of your personal computer (important
documents), copying files, or turning off the power.
NEC assumes no liability for any loss or damages arising from information leak or sys-
tem failure while you are using Desktop Control Utility 1.0.
•
In the Windows operating system, click [Control Panel] → [Performance and Mainte-
nance] → [Power Options] → [System Standby] → [Never]. This will disconnect LAN
connection when the personal computer goes in the standby mode while the Desktop
Control Utility 1.0 is being used.
•
The screen saver function is off while Desktop Control Utility 1.0 is running.
8
( Operation: page 54)
Office