Toshiba RAV-SM404MUT-E Service Manual page 96

No. Part name
1. Detachment
Heat
12
exchanger
1) Recover refrigerant gas.
2) Remove the refrigerant pipe at indoor unit
3) Perform work of procedure 10 -1.
4) Take off screws (Ø4 × 10, 3 pcs.) fixing the
5) While holding the heat exchanger, remove
2. Attachment
1) Mount parts in order, heat exchanger
NOTE)
Arrange wires as original.
2) Attach the removed connectors and wires as
3) Connect the refrigerant pipe as original, and
<Details of sensor lead wire drawing>
Procedure
side.
piping cover to remove the piping cover.
fixing band and fixing screws (Ø4 × 10, 3 pcs.)
and then remove the heat exchanger.
→ fixing band → piping cover → drain pan
→ bell mouth → electric parts box as original.
original.
then perform vacuuming.
TCJ sensor
(Black)
TC sensor
(Red)
Wind pipe cover over the header,
attach a sensor on it.
(Do not set the head of tie wrap upward.)
Fixing band
– 96 –
Remarks
Piping cover Piping cover
3 screws
Fixing band for
heat exchanger
2 fixing screws for heat exchanger