Panasonic AG-MX70E Operating Instructions Manual page 17

Parts and Their Functions
L
R
1
1
Analogue audio 1 input connectors
The audio signals supplied to these connectors are input
to the cross point selected on the initial setting page.
2 Analogue audio 2 input connectors
The audio signals supplied to these connectors are input
to the cross point selected on the initial setting page.
3 Analogue audio 3 input connectors
The audio signals supplied to these connectors are input
to the cross point selected on the initial setting page.
1
EDITOR interface connector (9-pin)
This connector is used to connect the unit with an RS-
422 or RS-232C controller.
2 RS-422/RS-232C selector switch
This is used to switch between the RS-422 and RS-232C
control protocols.
3 SIGNAL GND (ground) terminal
AUDIO IN
L L
R R
1 2
2 3
EDITOR
O
RS422
1
RS232C
1
TALLY
~AC IN
4
2
AUDIO OUT 1
R
16 (E)
L
R
L
3 4
4
4
Analogue audio 4 input connectors
The audio signals supplied to these connectors are input
to the cross point selected on the initial setting page.
5
Analogue audio output connectors
2
SIGNAL
GND
3
5
4 TALLY output connector
The rear panel tally is for the cross point 1, 2, 3, 4, 5, 6, 7
or 8 output.
The connector used by the cross point is turned ON.
Example of tally connections
AG-MX70
Tally output (Max. current: 50 mA)
GND
5 AC IN power socket
AUDIO OUT 1
R
5
(Max. voltage: 3.5V)
Tally LED