Panasonic AG-MX70E Operating Instructions Manual page 33

Effect-by-effect setting screens
[Pattern Edge] setting
This is used to set edges for the patterns. The border
colour set here is used as the border matte for trail. It is
updated by the colour which is read out for the direct
pattern.
Select [Hard], [Soft], [Border] or [Soft Border] using the
rotary 2 control. The default setting is [Hard].
When [Soft] or [Soft Border] has been selected, No.2001 to
2195 and 6008 to 6010 patterns cannot be selected.
When [Soft Border] has been selected, the #701 to No.707
(24 to 27), 801 to 814 (183 to 196) patterns cannot be
selected.
The [Width] thickness can be set to any value from 1 to 255
using the rotary 3 control. The default setting is 32. Only 1
or 2 can be set for [Width] if any of the following patterns
have been selected:
≥ No.701 to 707 (24 to 27), 801 to 814 (183 to 196)
Select the [Color] border colour using the rotary 4 control.
[White], [Yellow], [Cyan], [Green], [Magenta], [Red], [Blue],
[Black], [Custom1] or [Custom2] can be selected. Custom1
and Custom2 are colours which have been set by INT
Matte.
<Note>
When the PinP pattern has been selected and STILL is executed through B bus, the edge cannot be reflected.
R1 R2
Pattern
Edge Hard
Hard
Soft
Border
Soft Border
32 (E)
R3 R4 R5
Width Color
32 White
1 - 255
White
Yellow
Cyan
Green
Magenta
Red
Blue
Black
Custom1
Custom2