2.6.4 First Party Call Control CTI Connection
2.6.4 First Party Call Control CTI Connection
CTI connection between a PC and a KX-DT343/KX-DT346/KX-T7633/KX-T7636 DPT provides first party call
control. The CTI connection is made via a USB interface (version 2.0), and uses the TAPI 2.1 protocol.
A USB Module must be connected to the DPTs.
Note
The operating system of the PC required for first party call control depends on your CTI application
software. For details, refer to the manual for your CTI application software.
KX-DT343/KX-DT346
USB Port
USB Module
KX-T7633/KX-T7636
USB Cable
USB Module
Note
•
The maximum length of the USB cable is 3 m (9 ft 10 in).
•
USB Modules must not be connected to DPTs in the Digital XDP connection. In a Digital XDP
connection, the PC cannot be used. If a USB module is connected to a slave DPT, the DPT will not
work properly.
100
Installation Manual
USB Cable
To PC
To PC
USB Port
Document Version 2010-11