Panasonic KX-TDA50 Installation Manual page 112

2.10.1 Starting the PBX
3.
Plug the AC cord into the AC adaptor, and then plug the other end into an AC outlet.
AC Adaptor
To AC outlet
4.
Turn on the power switch. The RUN indicator will flash.
Power Switch
Note
•
For safety reasons, follow the procedures as indicated when turning on the PBX.
•
For safety reasons, do not stretch, bend, or pinch the AC cord and the DC cable of the AC adaptor.
5.
While the RUN indicator is flashing, slide the System Initialize Switch back to the "NORMAL" position.
Depending on the configuration, initialization takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and stay lit.
All data will be cleared, and the PBX as well as all optional service cards (except for the IP-GW4 card) will be
initialized to the default values. The DPTs should show the time as 01:00.
The data of the IP-GW4 card will not be initialized.
IMPORTANT
Use only the AC adaptor (Panasonic PSLP1434) and AC cord supplied with the PBX, or the
Additional AC Adaptor (KX-A236).
112 Installation Manual
AC Cord
Document Version 2010-11