Section A - Operating Instructions; Before Operating Your Dryer; Operating Steps; Cycle Selection - Electrolux 6000 Service Manual

SECTION A - OPERATING INSTRUCTIONS

Towels
Heavy Duty
Normal
Perm Press
Delicates
Touch Up
Timed Dry

Before Operating Your Dryer

Read your dryer Use and Care Guide. It has important
safety and warranty information. It also has many
suggestions for best drying results.
To reduce the risk of fire, electric shock
or injury to persons, read the IMPORTANT SAFETY
INSTRUCTIONS in your dryer Use and Care Guide before
operating this appliance.

Operating Steps

Read "Drying Procedures" in your Owners Guide. It
explains these operating steps in detail.
1. Prepare items for drying.
2. Check that lint screen is clean and in place.
3. Load the dryer. If desired, add a dryer fabric softener
sheet. Close the door.
4. Select the appropriate cycle and settings for
each load.
• Turn the Cycle Selector knob to select the cycle.
The estimated drying time will be displayed.
• A suitable drying temperature, dryness level and
options will automatically be indicated for each
cycle. See the "Dryer Setting Chart" for more
details.
• To change the temperature and dryness level, press
Temperature or Dryness until the desired
selections are made.
• To select or delete an option, press Options; then,
while the indicator is blinking, press Select. The
indicator will light when the option has been
selected. It will no longer be lighted when the
Maximum
High
More Dry
Medium
Normal
Low
Less Dry
Air Fluff/
Damp Dry
No Heat
Temperature Dryness
option has been deleted.
• If a temperature, dryness level or option is not
available for a cycle, it will not light.
• Adjustments to the cycle will be remembered
each time that cycle is selected in the future.
• To return to factory settings, press Start/Pause
and Select at the same time and hold until the
signal sounds.
5. Press Start/Pause to begin the cycle.
• To pause the cycle press Start/Pause. To
resume the cycle, press Start/Pause again.
• To stop or change the cycle, press Cancel.
6. A signal will sound at the end of the cycle and
periodically during Extended Tumble when the
Signal option is selected. When the cycle
ends, remove items immediately and hang or fold.
7. Clean the lint screen after every load.

Cycle Selection

Turn the Cycle Selector knob to the desired cycle. For
best results, follow the fabric care label instructions on
items to be dried. If the selection is changed after the
cycle starts, the indicator lights will blink, the signal will
beep and "ERR" will be displayed. To change the selection
after the cycle has begun, press Cancel before making
another choice. Just turning the knob to another selection
will not change the cycle. The signal will beep and the
status lights will flash, but the original cycle will continue.

Auto Dry

Auto Dry cycles take the guesswork out of drying time.
Loads dried using the Towels, Heavy Duty, Normal, Perm
Press, and Delicates cycles will dry automatically at
13
Shrink Guard
Extended Tumble
Signal Volume
Select Cancel
Start/Pause
Options
Drying
Cool Down
Extended
Tumble