Panasonic AG-CPD15P Operating Instructions Manual page 61

Viewing Live Video
<Simple On-Screen Display>
<Detailed On-Screen Display>
000
OWN
-----
----
2006-08-25
TRIGGER A B
Speed (MPH / KPH)
OWN : own vehicle speed
TGT : target vehicle speed
Target vehicle speed indication
depends on the type of radar gun
that is connected. For example, one
ProLaser3 measurement indicates
vehicle speed for a period of about
10 seconds. If another measurement
is made within this 10 second period
(approx.), the speed indication is
updated accordingly.
Note:
"ERR" appears to indicate that the
radar gun measurement result is
not correct.
Location information (latitude)
Location information (longitude)
Remaining P2 card recording time
(HHH : MM)
• The remaining recording time is
updated about every 30 seconds.
Note:
The total recording time does
not include prerecording and
postrecording time.
Mode indication
( : paused : recording)
(continued)
REMAIN 4:12 min
Restore
C1 IRA BL TAL LOCK
---
/TGT MPH
-- . -----
--- . -----
14:51:19
REMAIN 4:12 min
Restore
C1 IRA BL TAL LOCK
Status display
PON : power ON recording "ON"
INT : intermittent recording "ON"
<Status Display> (see "Status
Display" on page 122)
CARD FULL, CARD PROTECT,
VUP CARD, UNFORMATTED,
REFORMAT, ILLEGAL CARD,
NO CARD, CARD ERROR, RUNDOWN
Remaining time on the P2 card
Date/Time
Trigger signal (GPIO1-8) input status
(GPIO 1 to 8 are displayed in order
from the left.)
The characters assigned by
[Printable] appear when the state
set by [Detection] occurs.
Appears only when there is a file
that should be restored
Mark position
: Bookmark position
Setup status of this unit
C1 : [CAMERA1] connector input
is selected
C2 : [CAMERA2] connector input
is selected
IR : Camera IR mode is "ON"
IRA : Camera IR mode is "AUTO"
BL : Camera backlight
compensation is "ON"
TAL : Camera lamp is "ON"
LOCK : Operation button lock is "ON"
61