Rule Of Filename; Init Audio2 Rec - Panasonic AG-CPD15P Operating Instructions Manual

Administrator Setup
Rec Continue Time
Use this function to set recording
continue time for normal recording
when a trigger is entered or when
the [REC] button is pressed.
Setting (min.) : 1, 2, 5, 10, 15, 20, 30,
PreRec Time (Video)
Use this function to set how much of
already stored video will be retained
when a trigger is entered or the
[REC] button is pressed.
Setting (sec.) : 0, 10, 20, 30, 60, 90
PreRec Time (Audio)
Use this function to set how much of
already stored audio will be retained
when a trigger is entered or the
[REC] button is pressed. However,
the audio recording starts at the
same time when the video pre-
recording starts, even if the PreRec
Time (Audio) is set longer than the
PreRec Time (Video).
Setting (sec.) : 0, 3, 10, 20, 30, 60, 90
PostRec Time (Video)
Use this function to set the time
interval video recording will continue
after the [STOP] button is pressed.
Setting (sec.) : 0, 10, 20, 30, 60, 90
∗1 Intermittent recording and programmed recording extended by Rec Continue
Time do not stop.
∗2 Intermittent recording and programmed recording do not include prerecording time.
∗3 If recording is stopped by Intermittent recording, programmed recording and
Rec Continue Time, postrecording is not included.
∗4 Applies the setting in effect when power was last turned off. Unless power is
turned off properly, the operating state may not be saved correctly.
76
(continued)
∗
1
60, 90, CONTINUE
∗
2
∗
2
∗
3
PostRec Time (Audio)
Use this function to set the time
interval audio recording will continue
after the [STOP] button is pressed.
However, the audio recording ends
at the same time when the video
postrecording ends, even if the
PostRec Time (Audio) is set longer
than the PostRec Time (Video).
Setting (sec.) : 0, 3, 10, 20, 30, 60, 90

Rule of Filename

Use this function to set the rules for
filenames generated during recording.
WT : World time
LT : Local time

Init Audio2 Rec

Sets Audio2 recording when the
power is turned ON.
ON : recording is performed
OFF : recording is not performed
LAST : See footnote.
Init On Screen Type
Use this function to set On-Screen
Display used when the power is on.
Setting : AUTO, SIMPLE, DETAILS,
∗
LAST 4 , OFF
∗
3
∗
4