Panasonic AG-CPD15P Operating Instructions Manual page 82

Administrator Setup
Init IR Mode
Use this function to set the IR
function when the power is on.
Setting : AUTO
IR Level
Use this function to set the IR
function level during automatic
switching.
Setting : LOW, HIGH
IR Time
Use this function to set the IR
function detection time during
automatic switching.
Setting (sec.) : 10, 30, 60, 300
AUTO FOCUS
Selects color camera focusing
method when,
• [Init LPR Mode] is set to "DISABLE"
• [Init LPR Mode] is set to "ENABLE"
and [LPR Mode] is set to "PATROL"
• a recording trigger starts recording
when [Init LPR Mode] is set to
"ENABLE" and [LPR Mode] is set
to "LPR"
AUTO : Auto focus goes into
operation when the zoom
ratio is changed.
PRESET : When the zoom is 3x
or below, the camera is
focused at about 15 m
(50 feet). Subsequent
zooming will engage auto
focus.
DISABLE : Focus is locked at about
40 m (130 feet) and auto
focus is not available.
∗1 Automatically switches between ON and OFF.
∗2 Applies the setting in effect when power was last turned off. Unless power is
turned off properly, the operating state may not be saved correctly.
82
(continued)
∗
1 , OFF, ON, LAST
Init LPR Mode
Enables or disables the LPR
function (license plate recognition)
∗
2 when the recorder is turned on.
ENABLE : Allows changes to be
DISABLE : Color camera shutter
made to the officer [LPR
Mode]. Values set in this
mode will persist through
a power off and become
available at the next
power on.
s p e e d c h a n g e s
" A U T O " . T h e z o o m
position for the camera
at power on returns to the
position it had when the
power was last turned off.
t o