Ipk Ii Iad(8)-U( ) Programming; System Programming - NEC Electra Elite IPK II Installation And Maintenance Manual

C h a p t e r 3
___________________________________________________________________________________
S 1 S
ECTION YSTEM
The IAD (8)-U10 ETU is recognized by the Electra Elite IPK II system as a COI(4)/
(8)-U10 ETU, a COID(4)/(8)-U10 ETU, a DID(4)-U10 ETU, or a TLI(2)-U10 ETU, DTI
ETU based on the configuration on the ETU. This ETU takes longer to initialize than
the other Electra Elite IPK II ETUs.
First, program MB 14-02-01 Signaling Type (DP/DTMF). For the IAD trunks, this
must be set for Dial Pulse as follows:

The Electra Elite IPK II will recognize the IAD(8)-U10 ETU as a trunk card (according
to the DIP switch settings) and automatically program the slot.

To review the programming:
1.
2.
3.
4.
___________________________________________________________________________________
Hardware, Installation and Maintenance Manual

IPK II IAD(8)-U( ) Programming

P
ROGRAMMING
0 (10PPS)
or
1 (20PPS)
At default, 14-02-01 is set to 2 (DTMF).
Programming is available via PCPro, WebPro application, or a Multiline Terminal.
Enter programming: Speaker # * # * [system password] Transfer.
Go to Memory Block 10-03-01 by pressing the keys on keypad corresponding to
the memory block number.
With the flashing cursor on the "Slot No" field, press the softkey labeled +1 to
advance through the slots, until you reach the slot where the IAD H.323 Trunk
ETU has been inserted. It should show as the chosen trunk card.
If it does not show as the chosen trunk card, delete the current slot assignment.
Remove the IAD board from the KSU slot. Go to Memory Block 90-05-01. Press
Redial to advance to the "Slot Number" field. Enter the slot number and press
Transfer.
3 - 1