Host Name: (Default Value: Neciad; Ip Address: (Default Value: 192.168.1.100; Default Gateway: (Default Value: 192.168.1.1; Subnet Mask: (Default Value: 255.255.255.0 - NEC Electra Elite IPK II Installation And Maintenance Manual

H.323 Trunk
___________________________________________________________________________________

Host Name: (Default Value: neciad)

Enter the Computer Name for the IAD ETU. The IAD(8)-U( ) ETU is displayed as a
computer on the IP network.


IP Address: (Default value: 192.168.1.100)

This is the static IP address that is needed for the configuration. If used in a DHCP
environment where the IP address is automatically allocated by a DHCP server on the
LAN, make sure that the IP address is marked as RESERVED on the DHCP server.

Default Gateway: (Default value: 192.168.1.1)

Enter the default gateway for the IAD(8)- U( ) ETU in this field.

Subnet Mask: (Default value: 255.255.255.0)

Enter the Subnet mask for the IAD(8)- U( ) ETU. This is the same one you have been
using on your subnet.

Starting RTP Port Number: Default value: (49150)

Use this field to specify the RTP port number to be used. NEC recommends leaving
this field in its default value, unless otherwise required by the network administrator.

Country: (Default value: North America)

Choose the country where this card will be operating. When operating the card in the
United States and Canada choose North America.

Transmit/Receive Pad TX, RX: (Default value: (0,0)

These fields are useful for TLI/DID operation and provide the attenuation applied to
obtain adequate voice levels for the end users. Altering this value is not
recommended unless solving issues related to voice quality or echo.

Media TOS: (Default value: 0xC0)

IAD(8)-U( ) ETU sets this value (in Hex) in the 1-byte TOS field for outgoing voice
RTP packets. Refer to IETF RFC791 and subsequent RFCs describing the usage of
TOS field in the Internet.
___________________________________________________________________________________
Hardware, Installation and Maintenance Manual
When naming the host machine, the host name may contain only alpha characters,
numeric digits, and a dash. (A space and/or special characters are not allowed in the
host name field).
Document Revision 1
A - 3