Residual Moisture Sensor Brush Replacement - Miele Touchtronic T1302 Technical Information

T1302, T1303, T1322, T1329ci, T1323c,
T1403 and T1405 Clothes Dryers
4.9 Residual Moisture Sensor Carbon Brush - Replacement
Figure 030-8: Residual Moisture Sensor Brush Replacement
1. Remove the Lid (010 4.1).
2. Refer to Figure 030-8.
3. Lift the Brush Assembly arm and release the two brushes from
the arm.
4. Remove the snap on cover (1) from the arm.
5. Install the new brushes on the holder arm.
6. Cut the black wire (5), at the connector to the braided copper
wire. Install an insulating sleeve and splice the black wire from
the new carbon brush. Ensure the connection is tight and
sealed.
7. Cut off the green/yellow wire next to the double connection plug.
8. Connect the green/yellow wire from the new carbon brushes to
the double connector on the edge of the casing (7).
9. Secure the plug and wiring to the wiring retainers.
35
Technical Information