Fault Repair - Miele Touchtronic T1302 Technical Information

T1302, T1303, T1322, T1329ci, T1323c,
T1403 and T1405 Clothes Dryers
3

Fault Repair

3.1 Fault Summary
Turn on the appliance
1.
Select a program.
2.
Press Start.
3.
Allow the appliance to operate for at least two minutes.
4.
Observe the display for the following:
5.
Fault Signal
LED
Child Lock LED
flashes
Empty out container
LED lights
(condenser dryers
only)
Rotary iron LED
flashes (5 Hz)
Hand iron LED
flashes (5 Hz)
Anti-crease/Finish
LED lights
Anti-crease/Finish
LED lights
Anti-crease/Finish
LED lights
Table 060-1: Fault Summary
Buzzer
Fault
(if turned
Code
on)
– –
Intermittent –
Intermittent F2
Intermittent
F4
Intermittent –
Program time limit exceeded. Ensure the Heater Elements are
Intermittent F55
Programming / Electronic fault. Check wiring and connectors.
– F41
63
Cause
Check(s)
Lock function activated.
Turn off the Child Lock Feature (see 3.2)
Condensate container float switch.
Empty out condenser drawer. Check pump for correct
operation.
Heater Bank NTC Temperature Sensor (2R30).
Check the Temperature Sensor and circuit.
Drum Support housing NTC Temperature Sensor (1R30)
Fault.
Check the Temperature Sensor and circuit.
No load in drum or no-load registered by the Residual
moisture sensor. Ensure laundry is present. Check the
Residual Moisture Sensor circuit.
operating.
Replace the electronic.
Technical Information